Kitchen Mixer Faucet

Kitchen mixer faucet is the most important part of any kitchen. The choice of the tap, like the pull out kitchen mixer tap, in the kitchen depends on what you are going to wash. If it is stainless steel, the faucet should be chrome plated. And when the sink painted in any color, and the valve must be the same or close in color. In addition, the valve must fit the hole in the sink. It's best to buy them at the same time, matching them to each other.

1. Shut off the water supply to the riser in your home. So, let's keep in mind that the sink you already installed. Remove the faucet and hose tap connector from the packaging box. There you will see: crane; two flexible hose (one end with thin thread, the other under the nut); the semi-sphere, like the moon hole; the bolt without the cap is threaded; a nut to the bolt. Screw the flexible hoses to the faucet, use the key 10 to 11, if it does not fit, then pick up another key. At the thin end of the hose is threaded on the threaded end of the stand are two rubber o-rings. When tightening these rings should go inside of the crane and reliably block the hole. Very strongly do not tighten, you can strip the threads.

2. Wear rubber (plastic) ring at the bottom of the kitchen sink mixer faucet, it will lie between the faucet and the edge of the sink. Now skip steps through the hole. Put the tap in the hole. Take the bolt, screw the nut on it somewhere on 1 Please note that the bolt at the bottom should be a slot for a screwdriver. Slide over the bolt from the nut side of the hemisphere. From the bottom of the sink screw the bolt into the hole on the valve, tighten with a screwdriver until the end. Put faucet exactly, tighten the nut so that it has fixed its position. Again with effort tighten the bolt with a screwdriver. The crane should be fixed reliably, but, as a rule, they are always moving just a little bit.

3. Povedeniem in advance for water pipes and move them to a distance of 20 cm from the valve, secure shut-off valves. They are necessary, in the event of leaking taps to stop the water. To these taps with hot and cold water connect a hose to our faucet. Securely screwing them with more force. Now open the water, check the faucet.